PHONE +387 (0) 30 800 046       PHONE+385 (0) 1 353 5167          MAIL info@eps-lastro.com

pl ikonahr iconfikon.png

epslogo.png

flex.jpg

FLEX BITUFIX PES-5

Polymer bitumen high flexibility sheet for roof and under ground waterproofing

Polyester felt carrier coated with high flexibility polymer modified bitumen.

Surface finish is burn-off foil on both sides or sand on top and burn-off foil on bottom side.

icon-05-difuzijska-otpornost.png

Impermeability

60kPa

icon-02-tlacna-GLATKA.png

Thickness

5 mm

icon-10-rebrasta.png

Flatness

≤15mm/7,5m

icon-03-zatezna-cvrstoca.png

Tensile strenght 

500/300 N/50mm

icon-04-cvrstoca-na-povijanje_2.png

Stability on cold 

≤-5oC

icon-08-dimenzije.png

Dimensions

10x1m

tecnost.png

Stability to heat                          

≥+90oC

icon-06-standard.png

Standard

EN 13707:2009, EN 3969:2005,

icon-13-CE.png   icon-06-standard.png

Standard

EN 13969:2005/A1:2008 Type A i Type B

icon-11-klasa-gorivosti.png

Flammability

Euroclass F

 

 

Use:

Flex bitufix PES-5 is used in a single layer or in a multi layer waterproofing system beneath a top layer with permanent light or heavy surface protection where there is increased durability against both low and high temperatures required. Flex bitufix PES-5 is used for roofing and underground waterproofing against water under hydrostatic pressure.

Application:

Flex bitufix PES-5 sheets are installed by gas torch bonding full surface or only 10cm at overlap joints plus further 20cm of the total width (rest of it to be laid freely). According to the use intended sheets can be installed with or without mechanical fixing.

Packing:

Flex bitufix PES-5 sheets are available in 1m width and 10m length, palletised in thermo shrinking foil.

Storage:

Rolls must be stored and transported in an upright position. Must be stored in a dry and covered place, protected from direct sunlight. In winter conditions, before use, sheets should be stored at least 24 hours in the frost free space.

videotab Since 1966. 

The beginnings and development...

Company EPS LAŠTRO is the largest manufacturer of expanded polystyrene (trade name Styrofoam) in Bosnia and Herzegovina and leader of technological development and innovation in the facade system.

ABOUT US

 

nlbtn.png

Subscribe to our newsletter

to get news about our company and products ...

Resnik bb, Kreševo, BiH
Tel.: +387 (0) 30 800 046
Fax: +387 (0) 30 800 068
HR tel.: +385 (0) 1 353 5167
info@eps-lastro.com

fb tabenyt taben

EPS LAŠTRO © All rights reserved